When your lawn mower pull cord breaks, it can be frustrating, but fear not! Replacing the pull cord is a relatively simple task that you can do on your own with just a few tools and a bit of patience. In this comprehensive guide, we will walk you through the steps to replace the pull cord on your lawn mower, so you can get back to mowing your lawn in no time.
Gather Your Tools and Materials
Before you begin, make sure you have all the necessary tools and materials on hand. You will need a pair of needle-nose pliers, a new pull cord, a screwdriver, and some scissors. Once you have everything you need, you’re ready to start the process.
Step 1: Locate the Old Pull Cord
To begin, locate the end of the old pull cord inside the starter housing of your lawn mower. You may need to use needle-nose pliers to grab the cord if it’s stuck. Slowly pull the old cord out of the housing, making sure to remove it completely.
Step 2: Remove the Rope from the Handle
Once you have removed the old cord from the housing, it’s time to remove it from the handle. You can do this by either cutting the knot or untying it, depending on how it’s secured. Make sure to discard the old pull cord appropriately.
Step 3: Feed the New Pull Cord
Now, take your new pull cord and feed it from the outside of the starter housing to the inside. Make sure to thread it through any necessary guides or holes to ensure it’s properly aligned for reassembly. Once the cord is in place, you’re ready to move on to the next step.
Step 4: Secure the New Pull Cord
With the new pull cord in position, it’s time to secure it to the handle. Tie a knot at the end of the cord or use the manufacturer’s recommended method to ensure a secure attachment. Trim any excess cord with scissors, leaving just enough for a comfortable grip.
Step 5: Reassemble the Starter Housing
Next, carefully reassemble the starter housing, making sure the pull cord is properly aligned and not tangled. Use a screwdriver to tighten any screws or bolts that hold the housing in place, ensuring a snug fit that won’t come loose during use.
Step 6: Test the Pull Cord
Before you start the lawn mower engine, give the new pull cord a test pull to ensure it’s working correctly. You should feel resistance as you pull, and the cord should retract smoothly back into the housing when released. If everything checks out, you’re good to go!
