As a gardening and landscaping expert, I can provide you with detailed information about the application of Triad Select and whether it needs to be watered in or not. Triad Select is a product commonly used for lawn care and weed control. It comes in a concentrated form and needs to be mixed with water before application.
To apply Triad Select, you will need a backpack or pump sprayer. The recommended dosage is 1.5 ounces of Triad Select per gallon of water. Therefore, if you have a 1,000 square feet lawn, you will need to mix the appropriate amount of Triad Select and water in your sprayer.
Once you have mixed the solution, it is important to ensure an even distribution across the lawn. Start by walking in a systematic pattern, making sure to cover every inch of the lawn. It is essential to maintain a consistent application rate to avoid over or under-treating certain areas. This will help ensure effective weed control and prevent any potential damage to your lawn.
Now, let’s address the question of whether Triad Select needs to be watered in or not. The instructions specifically state that you should not water the product in after application. This means that after spraying the Triad Select solution onto your lawn, you should let it sit and allow it to dry naturally.
The reason for not watering in Triad Select is likely due to its formulation and mode of action. Some herbicides and pesticides require water to activate and penetrate the target plants or soil. However, Triad Select is designed to be absorbed through the foliage of the weeds.
By allowing the product to dry on the leaves, it ensures that the active ingredients have sufficient time to be absorbed into the plant tissues. This allows for maximum effectiveness in controlling and eliminating unwanted weeds.
It is important to note that the specific instructions and recommendations provided by the manufacturer should always be followed. They have conducted extensive research and testing to determine the best application methods for their product. Deviating from these instructions may result in reduced efficacy or potential harm to your lawn.
When applying Triad Select to your lawn, mix 1.5 ounces per gallon of water in a backpack or pump sprayer. Ensure an even distribution across the lawn, covering every inch of the area. After application, do not water the product in. Instead, let it sit and dry naturally on the leaves for maximum effectiveness in controlling weeds. Always follow the manufacturer’s instructions for best results.
I hope this information helps you in your lawn care endeavors! If you have any further questions or need additional guidance, feel free to ask.
